Roland VS-700R - Manual (Page 12)

12
Connecting Two VS-700R I/O Units
The Advantages of Connecting VS-700R I/O Units
By connecting two VS-700R I/O units, you'll be able to take advantage of the audio input/output of the two units,
have access to two synthesizers (Fantom VS), and be able to use two ARX expansion boards.
You will need a faster system if you connect two VS-700R I/O units.
Changes to the Settings
If you use a second I/O unit, open the top cover (ARX slot) of the second unit and set its SETTING DIP switches as
follows. Then turn the VS-700R’s power off, then on again.
fig.dsw2.eps
The audio/MIDI device names for the second I/O unit will be the same as for the first unit but with a “2”
added to the port name.
Connections
921
* To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the
power on all devices before making any connections.
1. Set the Sampling Rate of the two VS-700R I/O units to the same value (p. 18).
2. Connect the second VS-700R I/O unit to your computer’s USB connector.
Only ASIO is supported when using the audio input/output of the second unit
• Applications that do not support ASIO cannot be used
• The audio ports of the second unit cannot be selected if SONAR is set to the WDM/KS or MME driver
mode.
Normal setting Setting for the second VS-700R unit
VS-700R_e1.book 12 ページ ２０１０年６月１５日 火曜日 午後４時５９分