Roland VS-700R - Manual (Page 11)

11
Using the VS-700R I/O in Standalone Mode
To use the VS-700R I/O without connecting it to the VS-700C console, it needs to be set to “Standalone mode.”
While in Standalone mode, AUX IN cannot be used.
Changes to the Settings
In order to use the VS-700R I/O in “Standalone mode,” you need to open the top cover (ARX slot), then set the
SETTING dip switches to the positions shown below. Next, switch the unit's power off, then turn it back on again.
Normal setting Settings for Standalone mode
VS-700R_e1.book 11 ページ ２０１０年６月１５日 火曜日 午後４時５９分