Ricoh Type 3260 User Manual

Page 21

Setting Paper on the Bypass Tray

BBBB

Adjust the paper guides to the pa-
per size.

Important

❒ If the paper guides are not flush

against the paper, skewing and
misfeeds might occur.

CCCC

Gently insert paper face up into
the bypass tray until the beeper
sounds.

Extender

Paper guides

Note

❒ The beeper will not sound if it is

turned off. Gently insert paper
until it stops.

❒ Do not stack paper over the lim-

it mark, otherwise a skewed im-
age or misfeeds might occur.

❒ Open out the extender to support

paper sizes larger than A4

×11" L.

❒ Fan the paper to get air between

the sheets to avoid a multi-sheet
feed.

❒ When setting an OHP transpar-

ency, make sure that its front
and back sides are properly po-
sitioned.

❒ Select paper type when printing

onto OHP transparencies or
thick paper (over 127.9 g/m

For details, see p.17 “Setting
thick paper”.

DDDD

Select the paper size.

Note

❒ You can set paper size using the

printer driver. The following
procedures are not necessary
when setting paper size using
the printer driver.

❒ The paper size set using the

printer driver has priority over
that set using the display panel.

❒ When the printer driver is not

used, make settings using the
display panel.

❒ Thick paper and OHP transpar-

encies are delivered face up on
the top of the preceding page;
therefore, the prints need to be
rearranged into the correct or-
der. To avoid this, select [Re-
verse order print]

in the RPCS

printer driver settings to deliver
the prints in the correct page or-
der.

Reference

For printer driver settings, see
the printer driver Help.
For details about setting custom
sizes, see p.16 “Setting custom
size paper”.

A Press the {{{{User Tools/Counter}}}}

key on the control panel.

B Press [System Settings].

AEV005S

AEV028S

VenusC1GB-Printer-F8_FM.book Page 15 Tuesday, March 29, 2005 4:51 PM