RCA RD900W - Manual (Page 10)

Chapter 1: Connections and Setup
8 Chapter 1
Connecting the Lyra Wireless Receiver to your Audio Receiver
1. Connect the small end of the audio cable to the LINE OUT jack on the back of the Lyra Wireless
receiver and the other ends (the red and white plugs) to the Audio Input jacks (sometimes labeled
Aux or Line ) on your audio receiver. Also, make sure to put your audio receiver in the right mode
to receive the sound from those jacks (see your audio receiver’s owner’s manual for more
information).
2. Connect the small end of the small power supply to the power jack on the back of the Lyra Wireless
receiver and the other end into an AC outlet.
3. Make sure the CHANNEL switch is set to the same channel as the CHANNEL switch on the Lyra
Wireless transmitter.
4. Raise the antenna on the front of the unit so it is straight up.
5. Position the receiver so that it is facing in the general direction of the transmitter.
CHANNEL
9V
1 2 3 4 LINE OUT
POWER POWER
1
2
3
Important: Make
sure to push the
plug of the audio
cable all the way
into the LINE OUT
jack.