Roland V-Bass VB-99 - Manual (Page 54)

54
Chapter 5 Using MIDI
MIDI PC OUT
This setting determines whether or not Program Change messages
are output when the VB-99’s patches are switched.
1. Follow Steps 1–3 in “Setting the MIDI-Related
Functions” (p. 52) to display the MIDI screen.
2. Press PAGE [ ] [ ] to display Page 5.
3. Set PC OUT ON/OFF with [F1] or the F1 knob.
When outputting Program Change messages, the VB-99
simultaneously outputs MIDI Bank Select messages.
TX PC MAP (TRANSMIT PROGRAM
CHANGE MAP)
This setting determines the sequence of Program Change messages
output when the VB-99’s patches are changed.
You can select whether to output Program Change messages set for
the patches in advance or the Program Change messages
programmed in each patch.
1. Follow Steps 1–3 in “Setting the MIDI-Related
Functions” (p. 52) to display the MIDI screen.
2. Press PAGE [ ] [ ] to display Page 5.
3. Use [F2] or the F2 knob to set whether or not
the Transmit Program channel is used.
The table below shows the correspondence between the patches and
Program Change messages when TX PC MAP is set to FIX.
Available
Settings Description
FIX
Regardless of the patch settings, Program Change
messages predetermined for each patch number are
output.
PROG
The Program Change messages programmed in
each patch are output.
Patch
Number Bank Select Program
Number
001 0 1
: : :
100 0 100
101 1 1
: : :
200 1 100
201 2 1
: : :
400 3 100
VB-99_e.book 54 ページ ２００８年８月１８日 月曜日 午後１時１０分