Chapter 8 – Roland V-Bass VB-99 User Manual
Page 107
107
COSM BASS Chapter 8 Parameters Guide
Chapter 8
MIX
*1
Setting available when MODLNG TYPE for COSM BASS is set
to E.BASS, AC BASS, or E.GTR.
Parameter/
Range
Explanation
STRING PAN HiC, 1–4th, LowB
L0:100R–L100:0R
This sets the left/right pan of each string.
* The pan effect is cancelled if a monaural effect
or COSM amp is connected after the COSM
bass.
STRING LEVEL HiC, 1–4th, LowB
0–100
Specifies the output level of each string.
MIX LEVEL
COSM BASS
0–100
Specifies the level of the COSM bass.
NORMAL PU (Normal Pickup)
0–100
Adjusts the volume of the normal pickup.
NS (Noise Suppressor) *1
This effect reduces the noise and hum picked up by bass pickups.
Since it suppresses the noise in synchronization with the envelope of
the bass sound (the way in which the bass sound decays over time),
it has very little effect on the overall sound, and does not harm its the
natural character.
SW (Noise Suppressor Switch)
OFF, ON
Turns the NS effect on/off.
THRSH (Threshold)
0–100
Adjust this parameter as appropriate for the
volume of the noise. If the noise level is
high, a higher setting is appropriate. If the
noise level is low, a lower setting is appro-
priate. Adjust this value until the decay of
the bass sound is as natural as possible.
REL (Release)
0–100
Adjusts the amount of time from the point at
which application of the noise suppressor
begins to when the volume is fully attenuat-
ed.
VB-99_e.book 107 ページ 2008年8月18日 月曜日 午後1時10分