Roland DP-1000 - Manual (Page 20)

19
Connecting to Audio Equipment
When you connect the DP-1000 to audio equipment, you can
play the sounds from the DP-1000 through the speakers on
the audio equipment or record your performances on a tape
recorder or other recording device.
■ Connectors
fig.09-10
Output Jacks
You can connect audio equipment using audio cables (sold
separately) and play the sounds from the DP-1000 through
the speakers on the connected equipment or record your
performances on a tape recorder or other recording device.
Input Jacks
You can connect another sound source, such as audio
equipment or an electronic instrument using audio cables
(sold separately) and play the sounds from the connected
device through the speakers on the DP-1000.
■ Making the Connections
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
1. Turn the volume all the way down on the
DP-1000 and the device you’re about to
connect.
2. Turn off the power to both devices.
3. Use audio cables (sold separately) to make
the connection.
* When connecting a monaural device, you must connect it to the
L (Mono) jack of the DP-1000, and leave the R jack unused.
* Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction and/or
damage to speakers and other devices.
❍ Playing Sounds from the DP-1000 Through the
Speakers on Audio Equipment or Recording
Your Performances on a Recording Device
fig.59
1. Turn on the power to the DP-1000.
2. Turn on the power to the other connected
equipment.
3. Adjust the volume level on the DP-1000 and
the connected device.
❍ When Recording DP-1000 Performances on a
Recording Device
1. Connect the DP-1000 and other audio
equipment.
2. Start recording with the connected device.
3. Play the DP-1000.
4. When the performance ends, stop
recording on the connected equipment.
❍ Playing Audio Equipment Sounds Through the
Speakers on the DP-1000
fig.60
1. Turn on the power to the connected
equipment.
2. Turn on the power to the DP-1000.
3. Adjust the volume level on the DP-1000 and
the connected device.
* Raising the volume level of the connected device too high will
not only damage the DP-1000’s speakers, but may also cause
hearing loss. Listen at appropriate levels.
Output
R L(Mono)
Input
R L(Mono)
Stereo Stereo
DP-1000
Input R/L
(Line In, Aux In)
DP-1000
Output R/L
(Line Out)