Radio Shack ET-685 - Manual (Page 32)

32
If the base loses power while the handset is off of it, the security access-protection
code might change. Restore power to the base, then place the handset back on the
base and leave it there for a few seconds.
If you still have problems, disconnect the phone. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take your phone to your local RadioShack store for assistance.
Handset does not ring or receive a
page. Lift the base’s antenna to a vertical position.
Move the handset closer to the base.
Move the handset and base away from other electri-
cal devices.
Recharge the battery pack.
You have an incoming call, but do
not receive Caller ID information. Let the phone ring twice before you answer so the
system has time to record the Caller ID information.
Check that the system has been correctly and
securely connected.
Call your phone company to verify that your Caller ID
service is active.
Problem Suggestion
43-685.fm Page 32 Thursday, July 8, 1999 7:50 AM