Radio Shack ET-685 - Manual (Page 26)

26
To clear a stored number, simply
store a new number in its place. Or,
press
MEM twice. Then press the
memory location number ( 0 – 9 ) you
want to clear. A tone sounds.
Use the supplied memory directory
sticker to record your stored numbers.
Peel the backing from the sticker and at-
tach it to the base.
Entering a Pause
In some telephone systems, you must
dial an access code (9, for example) and
wait for a second dial tone before you
can dial an outside number. You can
store the access code with the phone
number. However, you should also store
a pause after the access code to allow
the outside line time to connect.
To enter a 2-second pause, press
PAUSE ( INTCM/PAUSE on the handset).
For a longer pause, press it additional
times.
Reviewing Memory Numbers
(Handset Only)
To review your memory numbers, press
MEMORY . The list of the first three mem-
ory location numbers (01–03) appears
with the name stored with each number
(or
if you did not store a
name). If necessary, scroll through the
list by repeatedly pressing or , or by
entering the two-digit location number.
To view the stored phone numbers,
press . An arrow to the right of the
number means it is longer than 14 digits.
Press again to see the rest of the
number. Repeatedly press
to return
to the name display.
To exit the memory number list, press
HOLD/CANCEL .
To see a stored name and phone num-
ber at the same time, press
SELECT
when the cursor is by a memory location
number. To exit this display without stor-
ing any changes, hold down
CONF/DE-
LETE until the display clears.
Dialing a Memory Number
To dial a number stored in the handset’s
memory, lift the handset from the base
and press
MEMORY . The list of the first
three memory location numbers ap-
pears. Choose a memory location (01–
30) by pressing number keys or by re-
peatedly pressing or , then pressing
LINE 1 or LINE 2 . The ET-685 automati-
cally dials out the number.
43-685.fm Page 26 Thursday, July 8, 1999 7:50 AM