Runco CW-50MC - Manual (Page 8)

OPERATION
The Runco CW-43MC and CW-50MC are standalone flat panel plasma displays with outboard VivixII™ video processing.
With 1024 x 768 native resolution for the CW-43MC and 1280 x 768 native resolution for the CW-50MC, both are capable
of imaging native HDTV. The CW-43MC and CW-50MC include a DVI digital input as well as standard analog inputs.
1. Install the Plasma display. This could be either table mount or wall mount configurations.
2. Connect the video interconnections between the output of any media source (such as DVD players or satellite receivers,
or a DTV or computer source) and the input of the plasma display.
3. Plug in AC power to the Plasma display, and turn the plasma on.
4. Select the desired source on the remote control and the source should now be displayed on the plasma. If it is not, please
check the wiring.
5. Clear the screen of any OSD menus.
6. From the remote, to access the INSTALLER ADJUST menu use a small paper clip or thin pen and press the ‘SVC’
button through the pin hole. (see Page 12 for more instructions)
7. Use the arrow ▲ UP and ▼ DOWN keys to select the adjustments options within each menu
• Press “SET” to select the adjustment option
• Press “SET” again to return to the INSTALLER ADJUST menu
NOTE: pressing the ‘MENU’ button will return back to the user mode, if nothing is done the plasma will return to
the user mode within 3 minutes.
• Press the ‘Menu’ button to save the settings and then return to the user mode.
7
General Overview
QUICK SETUP Instructions