Radio Shack 4-Line Telephone System with Speakerphone and Caller ID User Manual

Page 21

Memory Operation

The system’s line status indicators still show
the status of the line with a standard tele-
phone connected.

A standard telephone can join a call in the
system at any time. Call Privacy is automati-

cally released. If the person at the standard
telephone hangs up but you want to continue
the call, press

CONFERENCE

to restore Call

Privacy.

Memory Operation

You can store up to 20 phone numbers and
names in memory, then dial a stored number
by specifying the memory location.

Each stored number can be up to 16 digits,
and each name can be up to 14 characters.

STORING A NAME AND
NUMBER IN MEMORY

1. Press

PROGRAM

2. Select

3+21

then

1(;7

until

$872',$/

6(783

appears.

3. Select

(17(5

4. Repeatedly select

1(;7

until the desired

memory location (01–20) appears. Then
select

(',7

?180%(5!#

(or a number if the

location has previously been stored)
appears.

Note: Locations 01 to 10 are the upper
memories; locations 11 through 20 are
the lower memories. To access the
lower memories, press

LOWER

, then the

desired auto dial button (see “Dialing a
Stored Number” on Page 22).

5. Use the keypad to enter the stored num-

ber. If the number is entered incorrectly,
select

????

to move the cursor left, then

'(/

to remove the digits. Use the keypad

to enter the correct digits.

6. Select

1(;7

. Use the keypad to enter the

name. Press the key once to display the
first letter on that key, twice to display

the second letter, three times to display
the third letter, or four times to display
the fourth letter.

Pressing the key repeatedly cycles
through all the characters on the key.

7. Select

1(;7

to move the cursor to the

right after each letter.

For example, to enter “John”, press

once.

----

appears. Select

1(;7

, then press

three times.

2222

appears. Select

1(;7

then press

twice.

++++

appears. Select

1(;7

, then press

twice.

1111

appears.

To add a space, press

4444

8. Repeat Steps 6 and 7 until the name is

entered, then select

6$9(

to store your

entry.

9. Repeat Steps 4–8 to store additional

numbers.

10. Press

PROGRAM

to exit.

Use the memory card to keep track of your
stored numbers. Lift the card’s cover off,
write down the names and numbers, then
snap the cover back into place.

Entering a Pause

In some telephone systems, you must dial an
access code (9, for example) and wait for a
second dial tone before you can dial an out-
side number. You can store the access code
with the phone number. You should also

43-5709.fm Page 21 Wednesday, December 20, 2000 10:56 AM