Roland Metaza M PX -60 - Manual (Page 38)

36
2 Performing Marking
Driver Settings
Refer to this description for making settings for items other than the ones described earlier.
Enter the size of the marking area.
This corrects misalignment of the center point. For more informa-
tion, see "5 Troubleshooting", "The marked location isn't where
desired."
This chooses the units of measurement for the width and length.
This expands the marking area (this can be set up to a maximum of
80 x 80 mm (3-1/8 x 3-1/8 in.).
However, note that when marking is performed in an expanded area
(that is, outside an area of 50 x 50 mm (1-15/16 x 1-15/16 in. )), then
depending on the material and the image, unevenness in darkness
may occur.
This performs adjustment when the marking results are not what
you intended. See "5 Troubleshooting", "Images are unattractive."
This returns the corrected image values to the initial values before
correction (brightness = 0, contrast = 0, and gamma = 0.5).
This chooses the composition of the material to mark.
The optimal marking force for the material to mark is set. To make
fine adjustments in the marking force, click [Details...].
This marks a mirror image of the marking image.
To view the image during marking while marking is in progress,
make sure this is selected.
If quality is a priority, switch this off. Note that the time required for
marking is increased.
This saves the driver settings in a file.
This loads driver settings saved in a file.
Choose Text when printing text or images with clearly defined out-
lines.
Choose Photo when printing photographs or other images that con-
tain gradations.