Radio Shack TAD-764 - Manual (Page 8)

8
6. Route the adapter’s cord through
the strain relief slot on the base.
7. Plug the adapter into a standard
AC outlet.
When you first connect power, the
PLAY/SKIP indicator flashes (until
you record the outgoing message),
the ANSWER indicator flashes (if
you did not install a backup bat-
tery), and the TAD automatically
runs a self-test for about 20 sec-
onds. You cannot operate the TAD
during this test. When the test is
complete, the TAD Beeps once and
announces, “Answer off.”
On a Wall Plate
1. Plug one end of the supplied short
modular cord into the TO LINE jack
on the back of the base.
2. Route the cord into the groove on
the phone’s base.
3. Plug one end of the supplied coiled
cord into the jack on the bottom of
the base and route the cord into the
groove beside the jack.
Illus. showing cord rout-
ed through the strain re-
lief slot.
Illus. of ANSWER and
PLAY/SKIP indicators.
Illus of TO LINE jack and
end of modular cord about
to be inserted into jack.
Other connections are not
yet made.
Illus. showing routing of
modular cord.
Illus. showing routing of
coiled cord before it is
plugged into the handset.
43-764.fm Page 8 Friday, August 13, 1999 2:43 PM