Radio Shack TAD-764 - Manual (Page 20)

20
REMOTE OPERATION
You can operate the TAD from almost
any touch-tone phone, or from a rotary
phone using a pocket tone-dialer (avail-
able at your local RadioShack store).
Notes:
• When memory is full, the TAD
answers the call after two rings and
announces, “Memory is full.”
Delete some of the messages to
make room in memory.
• You must record an outgoing mes-
sage before you can remotely set
the TAD to answer calls.
• The TAD beeps three times if you
press a wrong button.
Follow these steps to operate your TAD
remotely.
1. Dial your phone number.
Notes:
• If the TAD is set to answer-off
and an outgoing message is
recorded, it answers the call
after 10 rings and announces,
“Answer off.”
• If the TAD is set to answer-on, it
answers according to the num-
ber of rings you set.
2. Within 8 seconds after the outgoing
message starts, enter the remote
operation security code. The TAD
beeps.
Note: If you do not enter each digit
of the security code within 8 sec-
onds, the TAD will disconnect.
3. Enter the remote command code
(see “Remote Commands” on
Page 21).
4. Hang up to end remote operation.
43-764.fm Page 20 Friday, August 13, 1999 2:43 PM