RCA B27TF685 - Manual (Page 64)

62 C HAPTER F OUR : VCR O PERATION
V C R O P E R AT I O N
Timer Record
CH : 7
START : 10:30 am
END : 12:30 pm
Date : 1/ 01/ 2002
Fri
Speed : SP
Mode : Once
VCR Setup
CH
Move Sel. Exit
10
Press the DOWN arrow
button to select “Mode”,
then press the UP/DOWN
arrow buttons to select
“Once”, “Wkly”, or “Dly”.
Timer Record
CH : 7
START : 10:30 am
END : 12:30 pm
Date : 1/ 01/ 2002
Fri
Speed : SP
Mode : Once
VCR Setup
CH
Move Sel. Exit
▼
For more information on
selecting tape speeds, see page 68.
9
Press the DOWN arrow
button to select “SPEED”,
then press the RIGHT
arrow button to select
speed at which you want
to record.
▼
11
Press the MENU button to exit the menu system and return to
normal viewing.
12
Press the POWER button to turn off the VCR.
To enter additional program
recording times, repeat steps 1-10.
If you enter two program times that
overlap, a program overlap warning
appears on the TV screen, along with
instructions for fixing the overlap.
The timer indicator on the front panel
of the TV illuminates when program
times have been stored.
The TV should be turned off to record
the programs you’ve chosen.
IMPORTANT:
• The TV should be off to record the programs you’ve chosen. But, if you are recording a channel
that comes through a cable box, be sure to leave the cable box turned on and tuned to the
channel you want to record.
• When a timer recording is in progress, there is no picture on the monitor because the power is
off. If you want to watch the channel while it's being recorded, press POWER
on the remote
control only.
• One-time timer programs clear from memory automatically when the recording is finished.
Daily and weekly programs remain in the timer until you remove them. If power to the TV is
interrupted,timer program will be removed from memory. The clock and calendar, however, must
be reset.
16061510-CHAPTER 4 12/13/02 11:48 AM Page 62