Radio Shack ET-1109 - Manual (Page 14)

14
USING REDIAL
You can quickly dial any of the last three
numbers you dialed recently. Lift the
handset and repeatedly press
REDIAL/
PAUSE until the number you wish to dial
displays. Then press TALK and the
phone dials the number.
Notes:
• You can also press REDIAL/PAUSE
after pressing TALK to dial the last
number dialed.
• The redial memory holds up to 32
digits, so you can redial long-
distance as well as local numbers.
• The redial memory also holds pause
entries. See “Entering a Pause” on
Page 17.
USING FLASH
FLASH performs the electronic equiva-
lent of a switchhook operation for spe-
cial services, such as Call Waiting.
For example, if you have Call Waiting,
press
FLASH to answer an incoming call
without disconnecting the current call.
Press
FLASH again to return to the first
call.
Note: If you do not have any special
phone services, pressing
FLASH might
disconnect the current call.
USING TONE SERVICES
ON A PULSE LINE
Some special services require tone sig-
nals (such as bank-by-phone). If you
have pulse dialing, you can still use
these special tone services by following
these steps.
1. Be sure DIAL MODE is set to P
(pulse).
2. Dial the service’s main number.
3. When the service answers, press
TONE ( ). Any additional numbers
you dial are sent as tone signals.
4. The ET-1109’s dial mode resets to
pulse when you make or receive a
call.
43-1109.fm Page 14 Friday, June 18, 1999 10:26 AM