Radio Shack ET-1109 - Manual (Page 13)

13
OPERATION
MAKING AND RECEIVING
CALLS
To make a call, lift the handset and
press
TALK (the CHARGE/IN USE indi-
cator on the base lights), then dial the
number. The number displays on the
handset as you dial, then (after a few
seconds) the call’s elapsed time dis-
plays.
You can also dial the number before you
press
TALK .
If you make a mistake, press DELETE
until the incorrect entry is erased, then
enter the correct number. To delete the
entire number, hold down
DELETE for at
least 2 seconds.
To answer a call, lift the handset from
the base and press
TALK . If auto talk is
on, just lift the handset from the base. If
the handset is away from the base,
press any key.
To end a call, place the handset on the
base or press
TALK .
SELECTING THE
CHANNEL
The ET-1109 has 30 channels (frequen-
cy pairs used between the base and
handset). If the call seems to disconnect
for no reason during a call, press
CH on
the handset to select a different channel.
The display shows
Scanning as your
phone searches for a clear channel.
ADJUSTING THE
HANDSET VOLUME
To adjust the volume of the sound you
hear through the handset during a call,
press
or on the handset until you
obtain the desired volume level. Vol-
ume Maximum , Volume High , Vol-
ume Medium , or Volume Low
displays on the handset.
Once you set the volume level, the set-
ting is maintained even after you hang
up the phone.
T A L K
M E M
F L A S H
T O N E
43-1109.fm Page 13 Friday, June 18, 1999 10:26 AM