RIDGID JP06101 - Manual (Page 34)

34
ACCESSORIES
Look for these accessories at The Home Depot:
� Jointer Knives.............................................................................................................................................................AC8600
Push Blocks ...............................................................................................................................................................AC8601
Dust Collection Kit......................................................................................................................................................AC8602
WARNING:
Attachments and accessories available for use with this tool are listed above. Do not use any attachments or
accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recom-
mended can result in serious personal injury.
TROUBLESHOOTING
Problem Cause Solution
Motor will not run
Wood strikes outfeed table
after passing over cutter
head
Ripples on planed surface
Kickbacks
Planed surface not straight
Excessive gouging at end
of cut
45°, 90° and 135° cuts
inaccurate
Infeed or outfeed table
loose
Cutter guard does not
function properly
1. Defective On-Off switch
Defective capacitor
Defective motor
2. Low line voltage
3. Belt tension too high
1. Outfeed table improperly adjusted above
cutter knives
1. One knife set higher than other
2. Feeding wood too fast
3. Cutting knives are set too high above
outfeed table, or they are not leveled with
outfeed table
1. Outfeed table out of adjustment
1. Outfeed table set too low
1. Fence stops not adjusted properly
2. Fence bottom not even with outfeed table
due to wood chips under fence
1. Loose gib
1. Return spring broken, or spring needs
adjustment
1. Consult an Authorized Service Center. Any attempt
to repair this electrical device may create a hazard
unless repair is done by a qualified service technician.
Repair service is available at your nearest Authorized
Service Center.
2. See “Troubleshooting (Motor)” section.
3. Adjust belt tension.
1. Readjust table, see “Outfeed Table Adjustment”
section.
1. Readjust knives, see “Maintenance” section.
2. Feed wood slower.
3. Readjust knives, see “Maintenance” section.
1. Readjust table, see “Outfeed Table Adjustment”
section.
1. Readjust table, see “Outfeed Table Adjustment”
section.
1. Readjust fence stops, see “Alignment” section.
2. Clean wood chips from underside of fence.
1. Tighten gibs.
1. Consult an Authorized Service Center immediately
if broken.
2. Adjust spring.