Assembly – RIDGID JP06101 User Manual

Page 19

ASSEMBLY

ASSEMBLING HANDWHEEL

See Figure 21.
n

Locate the following:

Pan Head Screw with Washer (1), 1/4-20 x 5/8 in.
Handwheel (1)
n

Slip the handwheel onto the infeed table elevation shaft

and install the pan head screw with washer as shown.

ASSEMBLING DUST CHUTE

See Figure 22.
n

Locate the following:

Sawdust Chute (1)
Wing Screws (2), 1/4-20 x 1/2 in.
Wrench Box (1), 8mm/10mm
Hex Key (1), 3mm
n

Slide the tab on the bottom side of the dust chute into

the slot just below the chute on the left side of the base.
Fasten the dust chute on with wing screws through the
slots on both sides of the dust chute.

The hex key and open end wrench (supplied with the

jointer) used for knife adjustments, can be conveniently
stored in the dust chute as shown.

NOTE: If a dust collection system is not in use, simply

loosen the wing screws, lift the bottom of the chute up,
out, and then slide the dust chute up and retighten the
wing screws.

ASSEMBLING FENCE ASSEMBLY TO

BED ASSEMBLY

See Figure 23.
n

Locate the following:

Washer (1),1/2 in.
T-Nut (1)
Fence Assembly (1)
Fence Lock Knob (1)
Fence Tilt Knob (1)
NOTE: While installing the fence, the two ribs on top of the

fence indicate where the cutter head opening is located
in the table.

NOTE: While installing fence to table, do not remove the

protective cutter guard covering.

Position fence onto fence support as shown, making sure

the keyway in fence assembly lines up with the key on
the fence mount.

Once fence is in place, slide the fence lock knob through

the 1/2 in. washer and then through the fence assembly
and fence mount. Thread T-nut onto the end of the lock
knob. Make sure the tabs on the nut sit in the slot on the
fence mount.

NOTE: Tabs on T-nut must be positioned upwards so

they fit in slot.

Slide the fence back and fourth to make sure it moves

freely. Then lock in place.

Thread the fence tilt knob into the fence.

Fig. 21

Fig. 22

Fig. 23

HANDWHEEL

PAN HEAD

SCREW

ELEVATION

SHAFT

DUST CHUTE

WING SCREW

FENCE

ASSEMBLY

FENCE MOUNT

T-NUT

FENCE LOCK

KNOB