RIDGID JP06101 - Manual (Page 31)

31
ADJUSTMENTS
USING ANGLE GAUGE
See Figure 44.
An angle gauge is included with the RIDGID jointer to set
the fence at the proper angle. To assemble the gauge slide
the one side over the other at right angles to each other. The
angle gauge has several faces for some of the more com-
mon angle settings. These angles include 90°, 45°, 30°, and
22.5°. There is also a 0°-45° protractor on one side to set
the fence to an angle not provided. Simply set the gauge at
the end of the fence on the outfeed table as shown and set
the angle you need.
ADJUSTING TABLE EXTENSION
See Figure 45.
The table extension is adjusted at the factory and should not
require any additional adjustments. In the event that it shifted
during shipping, align it to the outfeed table as follows.
n
Loosen the hex head screws that attach the extension to
the outfeed table.
n Using a straight edge, align the extension to be flush with
the outfeed table.
n Tighten the hex head screws and recheck the align-
ment.
ADJUSTING GUARD SPRING
See Figure 46.
n
Remove the pan head screw from bottom of the cutter
head guard post.
NOTE: The cutter guard stop post limits the amount of
cutter guard travel. Never modify the stop post or remove
cutter guard before any operation.
n Remove tension on cutter head guard by turning ten-
sion knob clockwise. Pull up on cutter head guard to
remove.
n Add tension to the cutter head guard in 1/2 turn incre-
ments by turning the tension knob and reinserting the
guard post.
n Repeat Cutter Head Guard Functional Check as previously
described.
NOTE: Do not overtighten the spring. Overtightening may
cause premature spring or guard breakage. If the guard
or spring breaks or malfunctions, do not use the tool.
Replace the defective parts before the tool is put back
in service.
n When the adjustment is complete, reinstall the pan head
screw in the bottom of the guard post.
Fig. 45
Fig. 46
Fig. 44
1 2 3 8 1 4
1 8
DEP TH OF CUT
GUARD
SPRING
SLOT
CUTTER
GUARD
PAN HEAD
SCREW
KNOB
COUNTERCLOCKWISE
TOP VIEW
OUTFEED
TABLE
SOCKET
HEAD
SCREW
EXTENSION EVEN
WITH OUTFEED TABLE
EXTENSION
�
ANGLE
GAUGE
CUTTER
GUARD
STOP POST