Assembly – RIDGID JP06101 User Manual
Page 18
18
ASSEMBLY
ASSEMBLING REAR PANEL
See Figure 18.
n
Locate the following:
Carriage Head Bolts (6), 5/16-18 x 1/2 in.
Hex Nuts Serrated Flange (6), 5/16 in.
Rear Cabinet Panel (1)
NOTE: Tabs on rear panel must be on the inside of side
panels prior to securing with nuts and bolts.
n
Position the rear panel in place from the bottom of the
cabinet as shown. Bolt in place using 5/16 in. carriage
head bolts and 5/16 in. flange nuts. Make sure the rear
panel’s tabs are on the inside of the cabinet. Tighten the
nuts.
n
Thread the power cord through the hole in the rear of the
cabinet.
n
Remove the screws and washers from the cable plate.
n
Thread the power cord through the hole from the inside
of the cabinet until the cord plate reaches the cabinet.
n
Reinstall the washers and screws from the outside of
the cabinet with the cord plate flush against the inside
of cabinet. Retighten screws.
NOTE: Securely tighten all cabinet nuts and bolts as well
as jointer table mounting bolts at this time.
ASSEMBLING AND TENSIONING BELT
See Figure 19.
n
Locate the V-belt.
n
Slip the V-belt over both the motor and cutter head
pulleys.
n
While the jointer is still upside down, slide the motor up the
motor mount to put tension on the V-belt. This will require
assistance. Once the V-belt has been tensioned, tighten
the motor bolts. The V-belt should have approximately
1 in. deflection (the measurement of how much you can
push in on one side of the V-belt).
NOTE: An alternate method for tensioning the V-belt is to
turn the unit upright, letting the motor slide down in the
slots and allowing the weight of the motor only to tension
the V-belt.
n
Visually check the front to back alignment of the pulleys
and adjust the motor as needed.
ASSEMBLING THE PULLEY GUARD
See Figure 20.
n
Locate the following:
Cross Serrated Pan Head Screws (4), 3/16-24 x 3/8 in.
Pulley guard (1)
n
With assistance, set the jointer upright.
WARNING
:
This tool is heavy. To avoid back injury, lift with your
legs, not your back, and get help when needed.
n
Mount the pulley guard in place as shown using 3/16 in.
screws.
Fig. 18
Fig. 20
Fig. 19
REAR PANEL
CABINET
V-BELT
SLOTS
1 IN. BELT
DEFLECTION
PAN HEAD
SCREW
PULLEY GUARD