RCA DRD212NW - Manual (Page 46)

44
Connecting the DSS Receiver
Connection C (Good Picture and Sound Quality)
To use this connection you must have:
• TV with RF input (jack)
• VCR with RF and audio/video inputs
• Coaxial and audio/video cables
To connect TV, VCR, and antenna or cable box.
1. Connect coaxial cables as shown.
2. Connect audio/video cables as shown.
To receive DSS programming:
1. Set DSS receiver 3/4 switch to CH3 or CH4 (whichever is not
being broadcast in your area.)
2. Tune TV to whichever channel you set the DSS receiver 3/4
switch to in the previous step.
To receive off-air programming (no cable box):
1. Turn DSS receiver off (or press TV/DSS button).
2. Turn VCR receiver off (or press VCR’s TV/VCR button).
3. Tune TV to desired channel.
To receive cable programming (with cable box):
1. Turn DSS receiver off (or press TV/DSS button).
2. Turn VCR receiver off (or press VCR’s TV/VCR button).
3. Tune TV to cable box output channel
(usually CH2, CH3, or CH4).
4. Tune cable box to desired channel.
To record DSS programming:
1. Set DSS receiver 3/4 switch to CH3 or CH4
(whichever is not being broadcast in your area.)
2. Tune TV to whichever channel you set the DSS receiver 3/4
switch to in the previous step.
3. Tune DSS receiver to desired channel.
4. Set VCR to record on line input.
To view VCR programming:
1. Tune TV to VCR output channel (usually CH3 or CH4).
2. Turn DSS receiver off (or press TV/DSS button).
Note: You can use your stereo amplifier line input to hear stereo using this
connection. See your stereo amplifier’s Owner’s Manual for specific information.