RCA DRD212NW - Manual (Page 38)

36
Setting Up the Remote
Setting up the Remote
The DSS remote can be programmed to control most brands of remote
controllable TVs. Most RCA, GE and ProScan TVs are already
programmed. Other manufacturer’s brands need to be programmed.
Installing the Batteries
Follow these steps whenever you need to install or change the batteries
in your DSS remote.
1. Pull off the cover of the battery compartment.
2. Place four AAA batteries as shown, matching the + and – end of
each battery in each compartment.
3. Replace the cover.
Programming the Remote to Control Your TV
To determine whether your remote needs to be programmed, turn the
TV on, point the remote at the TV, and press the TV button. Then press
CHAN UP or DOWN to see whether the TV responds to the remote
commands.
Follow these steps to program your remote to control your TV.
1. Turn on the TV.
2. Look up your brand and code number(s) on TV Code list on
the next page.
3. Press and hold the TV button.
4. Enter the three-digit code from the code list.
5. Release the TV button and press POWER or CHAN UP/DOWN
to see if the TV responds to the remote commands. If it doesn’t,
try the next code listed for your brand.
6. Repeat these steps until the TV responds to the remote
commands.
For easy reference, record your code here.
Note: For PROSCAN, RCA,and GE TVs, pressing the device button will usually
turn the device on; use the POWER button to turn the device off.