Radio Shack 43-3557 - Manual (Page 9)

Installation
9
O
N A
D
ESK
T
OP
1. Plug one end of
the supplied long
modular cord into
the
TEL LINE jack
on the back of the
base.
2. Insert the supplied
AC adapter’s
barrel plug into the
DC IN 9V jack on
the back of the
base and route the
adapter’s cord
through the strain
relief slot on the base.
3. Plug the other end of the modular cord
into a modular phone line jack.
4. Plug the adapter into a standard AC
outlet.
O
N A
W
ALL
P
LATE OR
W
ALL
To mount the phone directly on a wall, you
need two screws (not supplied) with heads
that fit into the keyhole slots on the base.
Drill two holes 3
15 /
16 inches apart. Thread a
screw into each hole, letting the heads
extend about
1 /
8
inch.
1. Insert the two of
upper tabs of the
supplied bracket
into the base’s
upper tab slots.
Then slide down
the bracket so that
two of the lower tabs would be inserted
into the lower slots.
TEL
LINE DC IN 9V
CAUTION
You must use
a Class 2
power source
that supplies
9V DC and delivers at
least 210 mA. Its center
tip must be set to
positive and its plug
must fit the phone’s DC
IN 9V jack. The supplied
adapter meets these
specifications. Using an
adapter that does not
meet these
specifications could
damage the phone or
the adapter.
!
43-3557.book 9 ページ ２００３年１２月１７日 水曜日 午後４時５４分