Radio Shack 43-3557 - Manual (Page 19)

Memory
Diali
n
g
19
• If you are not sure of your dialing
system, set for tone dialing. Make a
trial call.
If the call connects, leave the setting
as is, otherwise set for pulse dialing.
• If your phone system requires pulse
dialing and you need to send the
DTMF tones for certain situations
during a call, you may “switch-over”
to tone dialing. (Refer to “Tone
Dialing Switch-over” on page 15.)
Setting the Language
1. When the phone is in the standby
mode, press and hold CID .
2. Press VOL key four times to select
¨ Language ¨.
3. Press SELECT to toggle between ¨ Eng ¨,
¨ Fr. ¨ and ¨ Esp ¨ for each setting.
4. Press END or return the handset to the
base unit to complete the setting. The
handset returns to the standby mode.
MEMORY DIALING
S
TORING
P
HONE
N
UMBERS
AND
N
AMES
Memory Dialing allows you to dial a number
using just a few key presses. Your cordless
telephone stores up to ten names/numbers
in the handset. Ô
1. Press MEM , ¨ Select Memory ¨ is
displayed.
2. Press VOL or VOL keys, or enter a
number ( 0 - 9 ) to select the memory
location where you would like to store
the number.
Ô
NOTE
Ô
In memory dialing
operation, you must press
a key within 30 seconds or
the phone will return to the
standby mode. If you
return the handset to the
base, the phone will return
to the standby mode also.
43-3557.book 19 ページ ２００３年１２月１７日 水曜日 午後４時５４分