Radio Shack 43-3557 - Manual (Page 18)

Opera
tion
18
1. When the phone is in the standby
mode, press and hold CID . The Caller
ID setting screen appears.
2. Press VOL key twice to select ¨ Area
Code ¨.
3. Press SELECT .
4. Use the number keys ( 0 - 9 ), or CH/
DELETE to enter the three-digit area
code.
5. Press SELECT . A confirmation tone
sounds and the displayed area code is
entered.
6. Press END or return the handset to the
base unit to complete the setting. The
handset returns to the standby mode.Ô
Choosing the Dialing Mode
Most phone systems use tone dialing which
sends DTMF tones through the phone lines.
However some phone systems still use
pulse dialing such as in rural areas. Ô
The default setting is tone dialing.
Depending on your dialing system, set the
mode as follows:
1. When the phone is in the standby
mode, press and hold CID .
2. Press VOL key three times to select
¨ Dial ¨.
3. Press SELECT to toggle between
¨ Tone ¨ and ¨ Pulse ¨ for each setting.
4. Press END or return the handset to the
base unit to complete the setting. The
handset returns to the standby mode.
43-3557.book 18 ページ ２００３年１２月１７日 水曜日 午後４時５４分