Nortel Networks BST Doorphone - Manual (Page 8)

8 Chapter 2 DN configuration requirements for the BST Doorphone
NN40010-302
Use Table 2 to set line access parameters for the BST Doorphone.
4 Select the Capabilities and Preferences tab and select the DN. Additional tabs display in the
details panel. You must set parameters in the main panel and under the following tabs:
• Capabilities
• Preferences
Use Table 3 to set the capabilities and preferences for the BST Doorphone.
5 Repeat these steps for every BST Doorphone you plan to install on the system.
Table 2 Line access parameters
Tab Attribute Values Description
Main panel Fwd No Answer up to 24 digits Leave blank for the BST Doorphone.
Fwd Busy up to 24 digits Leave blank for the BST Doorphone.
Line Assignment Line read only Ensure there is no line assignment for this DN.
Line Pool
Access Line Pool read only Ensure that no line pool access is selected for this DN.
Answer DNs DN DN number Ensure that there are no Answer DN assignments for
the BST Doorphone.
Table 3 Capabilities and preferences
Tab Attribute Values Description
Main panel Prime line I/C Ensure that the prime line value is set to I/C for the
BST Doorphone.
Intercom (I/C)
keys 1 Assign only one intercom key to the BST Doorphone.
Control set None Set this value to None for the BST Doorphone.
Capabilities DND on busy check box Ensure that this check box is not selected for the BST
Doorphone.
Handsfree None
Standard
Auto
Set this value to Auto for the BST Doorphone.
Paging check box Ensure that this check box is selected for the BST
Doorphone.
Direct dial 0 - 9 Set this value to 0 for the BST Doorphone.
Preferences Aux ringer check box Ensure that this check box is not selected for the BST
Doorphone.
Hotline type None
Internal
External
Ensure that the Hotline type is sent to None.
Note: For a detailed explanation on all line access fields, refer to your BCM Configuration Guide.