Nortel Networks BST Doorphone - Manual (Page 13)

Chapter 3 BST Doorphone Installation 13
BST Doorphone Installation and Configuration Guide
Initialize a new BST Doorphone
The system automatically recognizes the BST Doorphone once it is installed and connected. Use
the following commands, to refresh the Element Manager view in order for the BST Doorphone to
appear in the Active Sets panel.
• In Element Manager, click on the IP address in the Network Elements pane. Go to the top
menu and select View > Refresh. Element Manager refreshes and the allows BST Doorphones
to appear in the system.
The BST Doorphone will identify itself to the system as a Doorphone.
Optional Equipment
The Door Opening Controller (DOC) operates through a BST Doorphone to provide door opening
control. The DOC receives data from the BST Doorphone, that is compared against a dip-switch
set code for activation.
The DOC provides convenient control of locked mechanisms but is not intended for sole building
entry security. In high security environments, backup systems should be used for added protection.
Power failure, device failure, wiring faults and unauthorized equipment access can all contribute to
a failed locked or unlocked situation.
For more information on the DOC, refer to documentation provided with the DOC unit.
Note: The Call button’s backlight automatically turns on when the
BST Doorphone is connected to a station module port on the
system. The backlight is useful in low light conditions.
✙
✙
Call button