Nortel Networks BST Doorphone - Manual (Page 7)

7
BST Doorphone Installation and Configuration Guide
Chapter 2
DN configuration requirements for the BST Doorphone
You can set up the DN record prior to a hardware installation, or you can install the hardware
before you configure the DN record. If you install the hardware first, Element Manager will
automatically detect the BST Doorphone and list it in the Active DNs table.
Creating a BST Doorphone DN record
Follow these steps to create a DN record for the BST Doorphone.
1 From Element Manager, click the Configuration tab and select Telephony > Sets > All DNs.
2 The All DNs panel contains three tabs: Line Access, Capabilities and Preferences, and
Restrictions. Depending on which tab is selected, different fields appear in the main panel and
the details panels. The All DNs pane displays the parameters shown in the table below
regardless of what tab is selected. Use
Table 1 to set the values for the BST Doorphone.
3 Select the Line Access tab and select the DN. Three tabs display in the details panel. You must
set parameters in the main panel and under the following tabs:
• Line Assignment
• Line Pool Access
• Answer DNs
Note: Some default DN settings can cause the BST Doorphone to automatically answer
incoming calls that are not intended to be heard over the BST Doorphone. For detailed
information about all DN settings, refer to your BCM Configuration Guide.
Table 1 Static information on the main panel
Attribute Value Description
Name characters> Use this field to provide a more specific description of the BST
Doorphone, such as BackDR for Back Door.
Model
Port
Doorphone Choose Doorphone for the BST Doorphone.
This read-only field shows the port number for the Set DN.
Remember this port number when you are installing the BST
Doorphone to a station module on the BCM system.