Nortec MH Series User Manual
Page 23
10-10
Page 19
2008-12-03
1.1.10 Configuring the Humidifier Maintenance Interval
Select “Maintenance” in the settings menu,
then press the
dialogue set the desired maintenance interval
time in hours. After the maintenance interval
time has elapsed a maintenance message
appears in the display and the yellow LED
lights up. If the maintenance is not performed
and the maintenance indication is not reset
within a certain time (168 h) , an error
message is triggered. Factory setting: 800 h
Setting range: 100... 50000 h
Note: to determine the maintenance interval
time please refer to 1.3 in section 10-40 of the
installation and operating instructions for the
Nortec MH.
1.1.11
Activating/deactivating the softstart function
If the mats in the humidifier boxes became dry due to a operation interruption, they
need a certain time until they are again moistened with water. In order to prevent too
much water flows over the humidification boxes in this phase and water droplets are
carried in the air flow, the amount of water can be reduced for a fixed time with the
“Softstart” function.
Select “Softstart” in the settings menu, then
press the
dialogue you can activate or deactivate the
softstart function. Factory setting: Off Options:
Off (Softstart function deactivated)
On (Softstart function activated)