Nortec MH Series - Manual (Page 11)

10-00
Page 7
2008-12-03
Info Page: Clean Trg. 1
This page shows the current settings for the time based and externally activated
forced draining/box cleaning (MHTC Reflow) or the box cleaning (MHTC Flow),
respectively.
Note: Wash = draining with simultaneous box cleaning (MHTC Reflow) or box
cleaning only (MHTC Flow), Drain = draining only.
– Time controlled draining/box cleaning (Timer).
– Actual time of day.
– Point in time of the next draining/cleaning cycle.
– Configured cleaning mode.
– Interval controlled draining/box cleaning (Periodic).
– Configured interval time in hours.
– Remaining time in hours up to the next
draining/cleaning cycle.
– Configured cleaning mode.
– Externally controlled draining/box cleaning
(Demand).
– Actual status of the draining/cleaning demand.
– Configured cleaning mode.
– Clean Trg. 1 deactivated (can appear only with
module MHTC Flow).
Info Page: Clean Trg. 2 (Note: This page is not shown with model MHTC Flow)
– Fill cycle controlled draining (Cycle).
– Number of fill cycles between cleaning/draining
cycles.
– Remaining fill cycles up to the next draining.
– Cleaning mode (Wash= Draining with simultaneous
box cleaning or box cleaning only, Drain= draining
only).
– Conductivity controlled draining/cleaning (µSensor) --
>Option.
– Set conductivity limit value inn µS/cm.
– Actual conductivity value of the water in the tub in
µS/cm.
– Configured cleaning mode.
– Operation-dependent draining deactivated (Off).