National Instruments Deterministic Ethernet Expansion Chassis NI 9144 - Manual (Page 8)

NI 9144 User Guide and Specifications 8 ni.com
Mounting the Chassis on a DIN Rail
Use the NI 9915 DIN rail mount kit if you want to mount the chassis on a
DIN rail. You need one clip for mounting the chassis on a standard 35 mm
DIN rail. Complete the following steps to mount the chassis on a DIN rail:
1. Fasten the DIN rail clip to the chassis using a number 2 Phillips
screwdriver and two M4
× 16 screws. National Instruments provides
these screws with the DIN rail mount kit.
Figure 7. Installing the DIN Rail Clip on the NI 9144 Chassis
2. Insert one edge of the DIN rail into the deeper opening of the DIN rail
clip, as shown in Figure 8.
Figure 8. One Edge of the DIN Rail Inserted in a Clip
1 DIN Rail Clip 2 DIN Rail Spring 3 DIN Rail
2
1
3