Nortel Networks FastRad User Manual

Page 21

FastRAD Installation Guide

Starting a
programming
session

The FastRAD cannot be used for remote or direct connections
until the user password has been programed through Feature
9**. This initial password programming must occur on-site.

IMPORTANT

: There is no way to recover a lost or forgotten

password or return to the default state.

A FastRAD is programmed from a Norstar two-line display tele-
phone that is connected to the KSU. Programming information
is entered into the FastRAD using the dialpad on the telephone.
Follow the prompts that appear on the display.

Note

: You cannot start a programming session while you are

on a call. When a programming session is in progress, press
only the buttons indicated. The programming session is termi-
nated when you press incorrect buttons or when you make or
answer a call. Only on a DR2 KSU can you put the programming
session on hold to make or answer a call.

If you need to go back a step while you are programming, press

BACK

or press

and start again. If you stop programming

for more than three minutes, the display returns to the date and
time, and you must restart programming from the beginning.

IMPORTANT

: You must wait 60 seconds before you attempt to

program the FastRAD when: the FastRAD is connected or
restarted; the power supply is disconnected or the KSU is
restarted.

To start a programming session:

Press

ƒ·••

The display shows:

Note

: When the password has been changed, the display

shows:

Enter password

. Check the FastRAD installation

wiring and start again if the display shows:

Inactive

feature

. For more information, refer to

Troubleshooting

later in this guide.

Password
EXIT CHNG NEXT

855601 Book : 855601 Guide Page 11 Wednesday, October 29, 1997 4:06 PM