Nortel Networks FastRad - Manual (Page 14)

4
FastRAD Installation Guide
Special check
list To begin an installation you need:
❑ an operating Nortel two-line display telephone
for programming the FastRAD
❑ a screwdriver
❑ two round head, size #8 wood screws, 1 inch long
❑ a roll of tape (or four tacks) for mounting the template
❑ a list of programming parameters for the FastRAD
❑ a unique System identification (ID) number
❑ a unique password
❑ the Norstar ICS Remote Tools software and
documentation package
*
Electrical
requirements Make sure the following electrical requirements are met:
❑ line voltage (120 V): 102 - 127 Vac
* If you are using a PC at the site to test the FastRAD installation, this package is required.
855601 Book : 855601 Guide Page 4 Wednesday, October 29, 1997 4:06 PM