Flash modes (using the flash), A54), se, A54) – Nikon AW100 User Manual
Page 78: Information on flash mode, A54), self-timer, A54) to, Mode (a54)
54
Features That Can Be Set Using the Multi Selector
Sh
ooting Feat
ures
Flash Modes (Using the Flash)
You can set a flash mode that suits the shooting conditions.
1
Press
H (m flash mode) on the multi selector.
2
Press the multi selector to select the desired
mode and press the
k button.
• See “Available Flash Modes” (
information.
• If the
k button is not pressed within a few seconds,
the selection will be canceled.
• When U (auto) is applied, D is only displayed for
a few seconds, regardless of Photo info settings
(
3
Frame the subject and take a picture.
• The flash lamp indicates the status of the flash when
you press the shutter-release button halfway.
- On: The flash will fire when you press the shutter-
release button all the way.
- Blinking: The flash is charging. The camera cannot
take pictures.
- Off: The flash will not fire when a picture is taken.
• If the battery is low, the monitor will be turned off
while the flash is charging.
C
Effective Range of the Flash
The flash has a range of about 0.3 to 3.5 m (1 ft to 11 ft) for wide-angle position, and about
0.5 to 2.2 m (1 ft 8 in. to 7 ft 2 in.) for telephoto zoom position (when ISO sensitivity is set to Auto).
Flash mode