Connect the network cables – NETGEAR FA510 User Manual

Page 4

Text mode
Original mode

Model FA510 Network Card Installation Guide

1. Using a UTP cable, connect any port on the hub to the port on the RJ-

45 adapter cable.

2. To connect the network cables, follow the illustration below.

Note: One of the ports on NETGEAR hubs is switchable between
Normal (MDI-X) and Uplink (MDI) with a Normal/Uplink push
button. If you are using this switchable port on a NETGEAR hub to
connect to a PC or the network card, make sure the Normal/Uplink
push button is set to Normal.

Connect the Network Cables

9026FA

RJ-45

connectors

PC with network
card installed

Power adapter

Notebook PC

*Use the cable provided or any Category 5 UTP cable.
Maximum length = 100 meters (300 feet)

Category 5 10/100 Mbps UTP cables*

Model FA510
Network Card with
RJ-45 adapter cable

Hub