Nokia DNT2Mi sp/mp User Manual
Page 29
Installing DNT2Mi
DN01145897
© Nokia Corporation
29 (128)
Issue 2-0 en
Nokia Proprietary and Confidential
2.
Fasten the mounting bar into the opening in the bottom of DNT2Mi with
the screw included. Use a Phillips screwdriver.
3.
Mark fixing points on the wall for two screws using the wall-mounting
bracket as schema (Figure 14).
-
Position the bracket on the wall in horizontal position, its hooks
facing upwards. Use a spirit level to check that the bracket is in a
straight position.
Figure 14.
Marking of fixing points for wall screws
4.
Drill holes (
≥ 45 mm) into the wall (Figure 15). Use a drilling machine with
a ø 6 mm drill bit.
•
Clean the holes and insert the included anchor plugs into the drilling
holes, if the wall material requires them.
Figure 15.
Drilling screw holes into a wall
100 mm
45 mm
ø 6 mm bit