NEC MATWORX NWA-008862-001 User Manual
Page 9
NWA-008862-001 Rev.2.1
Page 3
ajch1001.fm
CHAPTER 1 MATWorX
NOTE 1:
When you install the MATWorX program
on the PC using an OS of Windows 2000/
XP/Windows Server 2003, be careful about
the following:
- When a user without administrator per-
missions installs the MATWorX pro-
gram, this program cannot be started.
Therefore, to install the MATWorX pro-
gram, log in to the PC with administrator
permissions. In addition, when you start
the MATWorX after the installation, log
in to the PC with administrator permis-
sions.
- When more than one user installs the
MATWorX program on a PC, uninstall-
ing or upgrading the MATWorX pro-
gram cannot be done normally later.
Therefore, NEVER install the MATWorX
program on a PC from more than one us-
er.
NOTE 2:
To operate the MATWorX normally, exit
the other application such as mail software
before starting the MATWorX program.
The communication error will occur be-
tween the PBX and your PC by the inter-
ruption of the other application.
NOTE 3:
When connecting your PC to the PBX with
the modems, the 2-wire full duplex 28.8
kbps or higher modem is recommended to
your PC side. The modem must support the
AT command.
Since MATWorX Ver.6 or later, you can
use the built-in modem.
NOTE 4:
When connecting your PC to the PBX with
the modems, do not set the power saving
feature such as RESUME, SUSPEND,
STAND-BY on your PC.
1. MATWorX Overview
OCTOBER/31/2005