NEC MATWORX NWA-008862-001 - Manual (Page 15)

NWA-008862-001 Rev.2.1 Page 9
ajch1001.fm
CHAPTER 1 MATWorX
1. Connect the modem to your PC.
2. To use a built-in modem, set the SW2-4 of the
MP card to ON.
3. Mount the COT card in the system.
4. Set up the MATWorX and establish the
communication setting (Modem Connect)
between your PC and the PBX using
Configuration Wizard.
5. Set the following system data:
CM40 Y=10>1: Ч-ЧЧЧЧЧЧЧЧ (station number)
CM13 Y=07> Ч-ЧЧЧЧЧЧЧЧ (station number):0
NOTE: When using the built-in modem in the PBX,
RS1 port of the MP card cannot be used.
The requirements on the PBX side are shown below.
Requirements on PBX Side
Name qt. Remarks
COT card 1 Used for interface
between the PBX and
public network
2. Hardware Connections