NEC MATWORX NWA-008862-001 - Manual (Page 17)

NWA-008862-001 Rev.2.1 Page 11
ajch1001.fm
CHAPTER 1 MATWorX
LAN Connection
You can connect your PC to the PBX via the Ethernet
LAN.
LAN Connection
NOTE: The MP program downloading is not
available on LAN connection.
1. Make the Direct Connection.
For details, refer to “Direct Connection” .
Page 6
2. Set the following data using LAN interface Add-
In.
• IP Address
• Subnet Mask
• Default Gateway Address
NOTE: When the system was initialized by “B” (All
Clear), the following IP address and subnet
mask are set as a fixed value. Therefore you
can connect your PC to the PBX via the
LAN, even if you make your PC Direct
Connection (RS-232C connection) and do
not set an IP address using office data.
IP Address : 192.168.1.36
Subnet Mask : 255.255.255.0
[Series 3300 software (R8 software)
or later required]
PBX LAN
HUB/Router
PC
LAN Connector
LAN Cable
(10BASE-T/
100BASE-TX)
MP
ETHER
2. Hardware Connections