Network Technologies ST-xU - Manual (Page 28)

NTI NODEMUX SERIES UNIVERSAL KVM SWITCH
24
CA - change all output channels
FORMAT:
CA AA,XX
CA = "change all outputs" command followed by at least one space
AA = unit address
XX = input /CPU to connect to all outputs/USERS
RESPONSE: * (command received and executed OK)
? (syntax or transmission error occurred)
FYI: In this NODEMUX switch, the CA command will have the same effect as the CS command above.
RO - read single USER channel
FORMAT: RO AA,YY
RO = "read output" command followed by at least one space
AA = unit address
YY = output/USER to read
RESPONSE: * (command received and executed OK)
XX (XX = input/CPU connected)
-OR-
? (syntax or transmission error occurred)
RU - read unit size
FORMAT: RU AA
RU = "read unit size" command followed by at least one space
AA = unit address
RESPONSE: * (command received and executed OK)
XX,YY (XX = # of CPU’s, YY = # of USERS)
-OR-
? (syntax or transmission error occurred)
RV- read unit software version
FORMAT: RV XX,00
RV= "read software version" command followed by at least one space
AA= unit address
00= command for the address location in memory of the software version
RESPONSE: * (command received and executed OK)
RevIsion x.xx ST-8UV-DRW[000]
-OR-
? (syntax or transmission error occurred)
CF - reset all connected units, regardless of address, to factory default configuration settings
WARNING: THIS COMMAND WILL RESET ALL RS232 DAISY CHAIN CONNECTED NODEMUX SWITCHES TO
FACTORY DEFAULT SETTINGS. IF OTHER SWITCHES ARE DAISY CHAINED VIA RS232, DISCONNECT THEM BEFORE
SENDING THIS COMMAND.
FORMAT: CF 00
RESPONSE: (After 10-20 seconds)
COMMAND OK
RESET SWITCH CONFIGURATION IS COMPLETE
PLEASE RESET SWITCH POWER
FOR CHANGES TO TAKE EFFECT