Network Technologies ST-xU - Manual (Page 27)

NTI NODEMUX SERIES UNIVERSAL KVM SWITCH
23
Figure 24- Pinout of Matrix-Y-1 cable
Command Protocol
CPU controller commands supported by the unit are defined below. All commands should be terminated with a (carriage
return). When a command is sent, the entire string is echoed back along with a response from the addressed unit . All characters
in the command string should be upper case, and all numbers below 10 should have a leading 0 (ex: 1 = 01). As command
strings are sent, the inner character delay cannot exceed 500 milliseconds.
Note: To use this command protocol, the user is required to write a program that will send an entire command string all
at once, not character by character. Programs that send one character at a time (such as HyperTerminal) cannot be used
to control the NODEMUX. Alternatively, the user may use the NTI Switch Control Program or SerTest to control the
NODEMUX via RS232 (see page 25).
Terminal control commands supported by the NODEMUX are defined below.
RS - reset unit(s) to default power-up switch connections
FORMAT:
RS AA
RS = "reset unit" command followed by at least one space
AA = unit address; if 00, all units on the bus will be reset and no response will be
returned
RESPONSE:
* if command received and executed OK
-OR-
? if syntax or transmission error occurred
Note: The RS command does not change the switch configuration, it changes CPU-to-user connection settings.
CS - change single USER channel
FORMAT: CS AA,XX,YY
CS = "change single output" command followed by at least one space
AA = unit address
XX = input/CPU to connect
YY = output/USER to change
RESPONSE: * (command received and executed OK)
-OR-
? (syntax or transmission error occurred)
(Unit #1) (Source)
2 3
3 3
5 5 5
2 2
7
8
1
4
6
Jumper
Jumpers
Not connected to
source connector
(Unit #2)
9D Female 9D Male 9D Male
Wiring Schematic of Matrix-Y-1 cable