Electronically controlled cameras – Nikon Coolpix S1100pj User Manual
Page 201
187
Troubleshooting
Tec
h
nica
l N
otes and
Ind
e
x
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon-authorized service representative. Note that disconnecting
the power source as described above may result in the loss of any data not
recorded to internal memory or the memory card at the time the problem
occurred. Data already recorded will not be affected.
Date not appearing on pictures
even when Date imprint is
enabled.
• Another function that restricts the Date
imprint option is enabled.
• The current shooting mode is one that does
not support Date imprint.
Camera settings reset.
Clock battery is exhausted; all settings were
restored to their default values.
Monitor turns off, and the
power-on lamp blinks rapidly.
Battery temperature is high. Turn off camera and
allow battery to cool down before resuming use.
After the lamp blinks for three minutes, the
camera will turn off automatically. Pressing the
power switch also turns off the camera.
Camera does not respond to
remote control operation.
• Battery of the remote control is exhausted.
• Point the remote control at the infrared
receiver on the front or rear of the camera at
the distance within approximately 5 m (16 ft.).
• The remote control cannot be used when
Smile timer is set to On in smart portrait
mode and the camera detects human faces.
• The shutter may not be released when
attempting to use the remote control to take
pictures of scenes exhibiting severe
backlighting.
–
Problem
Cause/Solution
A