Configuring the network module, Figure 2-11. typical signal connections for host c, Figure 2-12. address and baud rate switch – National Instruments FP-1001 User Manual
Page 20: Configuring the network module -9, Multiple fp-1001 network modules -9, Figure 2-12. address and baud rate switch -9, 11 sh
Chapter 2
Installation and Configuration
© National Instruments Corporation
2-9
FieldPoint FP-1000/FP-1001 User Manual
Figure 2-11. Typical Signal Connections for Host Computer Connected to Multiple
FP-1001 Network Modules
Configuring the Network Module
Figure 2-12 shows the 8-position switch on the FP-1000 and FP-1001
FieldPoint network modules. Switches 1-5 set the network address, and
switches 6-8 set the baud rate.
Figure 2-12. Address and Baud Rate Switch
120
Ω
120
Ω
120
Ω
120
Ω
From Host
Computer's RS-485
Transmit Output Pair (TX)
To Host
Computer's RS-485
Receive Input Pair (RX)
FP-1001
FP-1001
FP-1001
+
+
–
–
RX
TX
RX
TX
RX
TX
Connect the TX outputs of the host computer to the RX inputs of the FP-1001,
and the RX inputs of the host computer to the TX outputs of the FP-1001.
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
Address
Baud
Rate
Switch Cover
(Removed)