Nortel Networks NN46200-301 - Manual (Page 9)

Command line interfaces 9
Table 1
NNCLI command modes
Command
mode
Prompt
Mode
name Command/mode
to enter or exit mode
User EXEC ERS-8300:5> Exec Default mode
when NNCLI is started
logout to exit
Privileged
EXEC ERS-8300:5# privExec enable to enter
from User EXEC mode
disable to exit
to User EXEC mode
Global
Configuration ERS-8300:5(config)# config configure to enter
from Privileged EXEC
mode
exit to exit
to Privileged EXEC
mode
Interface
Configuration ERS-8300:5(config-if)# config-if interface to
enter from Global
Configuration mode
exit to exit
to Global Configuration
mode
Accessing the NNCLI
When you first power up the Ethernet Routing Switch 8300, the default
interface is the Ethernet Routing Switch 8300 CLI. To switch from the CLI
to the NNCLI, you must change the NNCLI boot flag to
true and save the
boot configuration file using the following commands:
ERS-8310:5# config boot flags nncli true
ERS-8310:5# save boot
You must reboot the switch for this change to take effect. After you reboot
the switch, access the NNCLI using Telnet, rlogin, or the local console port.
You can log in to the switch using your password and the default privilege
password
nortel .
Use the following commands to:
• log in to the software using the default user name and password
• access Global Configuration mode
Login: xxxxx
Password: xxxxx
ERS-8310:5> enable
Nortel Ethernet Routing Switch 8300
Installation — AC Power Supply
NN46200-301 03.01 Standard
4.0 27 August 2007
Copyright © 2007, Nortel Networks
.