Nortel Networks NN46200-301 - Manual (Page 13)

13
Power supply installation
This guide contains information about installing power supplies.
Navigation
• "Power supplies" (page 13)
• "Removing and installing a power filler panel" (page 17)
• "Installing the AC power supply" (page 18)
• "Removing the AC power supply" (page 20)
Power supplies
The Ethernet Routing Switch 8306 and 8310 chassis have three bays for
power supplies. Use the AC power supply for AC input power. The following
figure shows an Ethernet Routing Switch 8301AC power supply. The
nominal input voltage range for the 8301AC power supply is 100-120 VAC
and 200-240VAC, however, the output power is limited to 1140 W maximum
at 100-120 VAC nominal input voltage conditions. To obtain full output
power (1770 W), you must connect the 8301AC power supply to a 200-240
VAC nominal input voltage source.
Nortel Ethernet Routing Switch 8300
Installation — AC Power Supply
NN46200-301 03.01 Standard
4.0 27 August 2007
Copyright © 2007, Nortel Networks
.