Nortel Networks NN46200-301 - Manual (Page 17)

Removing and installing a power filler panel 17
Removing and installing a power filler panel
A power filler panel maintains the proper cooling airflow in the Ethernet
Routing Switch 8300 Series chassis. If you remove a power supply from the
Ethernet Routing Switch 8300 Series chassis without replacing it, you must
install a power filler panel. When you install a power supply, you must first
remove the power filler panel from the power bay.
To remove a filler panel:
Step Action
1 Using a Phillips screwdriver, loosen the two captive screws that
fasten the power filler panel to the chassis until the screws are free
of the threads in the chassis frame.
2 Pull the power filler panel out of the Ethernet Routing Switch 8300
Series chassis.
Save the power filler panel in case you need to operate the Ethernet
Routing Switch 8300 Series chassis with a power supply removed.
—End—
To install a power filler panel:
Step Action
1 Place the power filler panel in the empty power supply bay.
2 Tighten the two captive screws until the power filler panel is seated
firmly.
Nortel Ethernet Routing Switch 8300
Installation — AC Power Supply
NN46200-301 03.01 Standard
4.0 27 August 2007
Copyright © 2007, Nortel Networks
.