Nortel Networks NN46200-301 - Manual (Page 11)

Hard-copy technical manuals 11
brackets ([ ]) Indicate optional elements in syntax descriptions.
Do not type the brackets when entering the
command.
Example: If the command syntax is
show ip interfaces [-alerts] , you can
enter
either
show ip interfaces or
show ip interfaces -alerts .
ellipsis points (. . . ) Indicate that you repeat the last element of the
command as needed.
Example: If the command syntax is
ethernet/2/1 [ ]... ,
you enter ethernet/2/1 and as many
parameter-value pairs as needed.
italic text Indicates variables in command syntax descriptions.
Also indicates new terms and book titles. Where
a variable is two or more words, the words are
connected by an underscore.
Example: If the command syntax is
show at ,
valid_route is one variable and you substitute one
value for it.
plain Courier text Indicates command syntax and system output, for
example, prompts and system messages.
Example: Set Trap Monitor Filters
separator ( > ) Shows menu paths.
Example: Protocols > IP identifies the IP command
on the Protocols menu.
vertical line ( | ) Separates choices for command keywords and
arguments. Enter only one of the choices. Do not
type the vertical line when entering the command.
Example: If the command syntax is
show ip {alerts|routes} , you enter either
show ip alerts or show ip routes , but not
both.
Hard-copy technical manuals
You can download current versions of technical documentation for your
Ethernet Routing Switch 8300 from the Nortel customer support web site
at
www.nortel.com/support .
Nortel Ethernet Routing Switch 8300
Installation — AC Power Supply
NN46200-301 03.01 Standard
4.0 27 August 2007
Copyright © 2007, Nortel Networks
.