Netcomm gateway – NetComm N300 User Manual

Page 47

YML9WMAXXN

ADSL2+ Wireless N300 Modem Router with VoIP User Guide

www.netcomm.com.au

NetComm Gateway

Series - ADSL2+ Wireless N300 Modem Router with VoIP

The graphic below shows an example of three protocols over the same connection.

8.1.2 MSP

Multi-Service over PVC (MSP) supports multiple protocols over a single connection. As with the VLAN Mux function, PPPoE, Bridge and
MER protocols can coexist, while IPoA and PPPoA are not supported. This function supports remote management by bridge protocol in
addition to multimedia applications over a single PVC.

Configuring MSP is a two-part process:

Part 1 -

Create multiple PVCs (One Bridge + multiple PPPoE / One MER)

Part 2 -

Use Port Mapping to connect LAN / WAN interfaces

NOTE:

The example below shows how to configure a Bridge / PPPoE MSP connection. Use the same process for
Bridge / MER MSP connections.

If QoS is configured on the first MSP connection, it will be configured by default for all subsequent connections.

If a MSP connection is removed every other MSP connection should be removed to avoid port mapping configuration problems.

Part 1 – Create Multiple PVCs
On the Advanced – WAN screen, create one PPPoE connection and one Bridge connection on the MSP supporting PVC. The screen will
display as follows.

Part 2
Go to Advanced – Port Mapping screen (see section 9.9 Port Mapping) and select the Enable Virtual Ports checkbox. The screen will
display as follows.

NOTE:

Only hardware ports and bridge PVCs are listed as interfaces. The bridge interface is shown as “nas_x_y_z” where x=port, y=vpi, and z=vci.

To continue, click the Add button at the bottom of the screen shown above.