NetComm N300 - Manual (Page 43)

YML9WMAXXN ADSL2+ Wireless N300 Modem Router with VoIP User Guide
www.netcomm.com.au 43
NetComm Gateway TM Series - ADSL2+ Wireless N300 Modem Router with VoIP
7.5 Access Control
The Access Control option under the Management menu configures three access-related parameters: Services, IP Address and
Passwords.
7.5.1 Services
The Services option limits or opens the access services over the LAN or WAN. These services are provided FTP, HTTP, ICMP,SNMP, SSH
(Security Socket Share), TELNET, and TFTP. Enable the service by checking the item in the corresponding checkbox, and then click Save/
Apply.
7.5.2 Access IP Addresses
The IP Addresses option limits access by IP address. If Access Control Mode is enabled, only the IP addresses listed here can access the
router. Before enabling it, configure the IP addresses by clicking the Add button. Enter the IP address and click Apply to allow the PC with
this IP address to manage the device.
7.5.3 Passwords
The Passwords option configures the access passwords for the router. Access to your router is controlled through three user accounts:
root, support, and user.
• root has unrestricted access to change and view the configuration of your router. It is the top administrative account.
• support is intended to allow limited access so that a technical support representative can conduct maintenance and run
diagnostics.
• user provides the least access control but allows for viewing configuration settings and statistics, as well as, updating software.
Use the fields below to enter up to 16 characters and click Save/Apply to change or create passwords. See section 3.3 Default Settings
for the default passwords.